IEC 60384-15:2017 pdf download

IEC 60384-15:2017 pdf download.Fixed capacitors for use in electronic equipment – Part 15: Sectional specification: Fixed tantalum capacitors with non-solid or solid electrolyte
1 General
1 .1 Scope
This part of IEC 60384 applies to through-hole/leaded polar and bipolar tantalum electrolyte capacitors with solid and non-solid electrolyte for use in electronic equipment. It includes capacitors for long-life applications and capacitors for general-purpose applications. Capacitors for special purpose application may need additional requirements. This document covers two basic sub-families: • Sub-family 1 : Fixed non-solid electrolyte tantalum capacitors with porous anode. • Sub-family 2: Fixed solid electrolyte tantalum capacitors with porous anode.
1 .2 Object
The object of this document is to prescribe preferred ratings and characteristics and to select from IEC 60384-1 :201 6 the appropriate quality assessment procedures, tests and measuring methods and to give general performance requirements for this type of capacitor. Test severities and requirements prescribed in detail specifications referring to this sectional specification shall be of equal or higher performance level, because lower performance levels are not permitted.
1 .3 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IEC 60063, Preferred number series for resistors and capacitors IEC 60068-1 :201 3, Environmental testing – Part 1: General and guidance IEC 60068-2-6, Environmental testing – Part 2-6: Tests – Test Fc: Vibration (sinusoidal) IEC 60068-2-1 4, Environmental testing – Part 2-14: Tests – Test N: Change of temperature IEC 60384-1 :201 6, Fixed capacitors for use in electronic equipment – Part 1: Generic specification IEC 6041 7, Graphical symbols for use on equipment IEC 61 1 93-2:2007, Quality assessment system – Part 2: Selection and use of sampling plans for inspection of electronic components and packages
1 .4 Information to be given in a detail specification
1 .4.1 General Detail specifications shall be derived from the blank detail specification. Detail specifications shall not specify requirements inferior to those of the generic, sectional or blank detail specification. When more severe requirements are included, they shall be listed in 1 .9 of the detail specification and indicated in the test schedules, for example, by an asterisk. The information given in 1 .4.2 may, for convenience, be presented in tabular form. The following information shall be given in each detail specification and the values quoted shall preferably be selected from those given in the appropriate clause of this sectional specification. 1 .4.2 Outline drawing and dimensions There shall be an illustration of the capacitors as an aid to easy recognition and for comparison of the capacitors with others. Dimensions and their associated tolerances, which affect interchangeability and mounting, shall be given in the detail specification. All dimensions shall preferably be stated in millimetres. However, when the original dimensions are given in inches, the converted metric dimensions in millimetres shall be added. The numerical values of the body shall be given as follows: • for general: the length, width and height; • for cylindrical body: the diameter and length. The numerical values of the terminals shall be given as follows: • for general: the spacing; • for leaded terminals: the diameter and spacing. When the configuration is other than described above, the detail specification shall state such dimensional information as will adequately describe the capacitor. 1 .4.3 Mounting The detail specification shall specify the method of mounting to be applied for normal use and for the application of the vibration and the bump or shock tests. The design of the capacitor may be such that special mounting fixtures are required in its use.